![]() Again, I am regretting becoming an early adopter and should have just paid the money to get the DSP version of other laser software, but I have little/no desire to learn yet another software platform. Check compatability.").Įxpecting the average end-user to figure out the rest of what is required to make the laser module work (as per the help document for the laser module/post processor) is a little much, I think. I tried placing the modified files (I added the "LASER_SUPPORT = "YES" into the PP) in both locations (PP and MyPostP folder) and I keep getting the same error/issue ("Error occurred while outputting toolpath. I was using the Axiom_HHC_Laser.pp and Axiom_HHC_Laser_V2.pp from the JTech site (it worked before I updated to 10.5 and purchased the laser module). LaserTools.zip (5.41 KiB) Downloaded 542 timesĪll of the postprocessors in MyPostP folder are the same ones that migrated over from 10.0. I've exported the standard ones we include and attached them if you would like to import them into your database. We did include some "standard" lasers in the tool database, these were based on our own usage on test machines, but if you have migrated an existing tool datbase they may not be included. We filter posts by whether or not there is anything in the My_PostP, and then we also apply a laser-specifc filter. There are two levels of filtering on the laser post-processors and almost certainly this is causing the issue.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |